As caregivers, we understand why having a bed alarm & chair alarm system that you can count on makes a difference!

With the Lunderg smart technology ecosystem, you can keep your elders safe wherever they may end up. Simply put, it makes your life so much easier.

1. Step 1 - Turn ON the Bed Pad

   
   

   First put the batteries into the monitor and loop the bands through the clips and eyelets on the bed pad.

   Before you attach the pad to the bed pull back the sheet and turn the pad ON by opening the transmitter pocket.

   • If using a king-sized bed or a bed with only one side to exit, set the pad to TX-only and place it on one side of the bed. NEVER SET IT IN THE MIDDLE!
   • If using a twin-sized bed, with loved one exiting the bed from both sides of the bed, set the pad to Both-sides.

2. Step 2 - Pair the Bed Pad with the Monitor

   
   

   Next turn ON the monitor and press the “PAIR” button on the monitor until the status LED light turns a steady green. Make sure to complete the pairing before the lights turns off! Then press and release the center zone of the bed pad to pair it with the monitor. The Status LED light won’t be steady anymore and the Sensor 1 red LED light will blink once to indicate it has been recorded. Just to be safe, please do a quick test.

3. Step 3 - Secure the Bed Pad to the Bed

   
   

   Position the sensor pad across the bed beneath where the hips of the patient will be, and make sure the neck of the pad is hanging off the edge of the mattress.

   Then secure the pad to the bed, using the clips and rubber bands. Pull the bands tight so the pad will have minimal movement, which greatly reduces false alarms.

   Last cover the bed pad with the fitted sheet.

4. Step 4 - Turn ON the Chair Pad

   
   

   Next, open the transmitter pocket which is located at the back of the chair pad. Inside the pocket, you can find the transmitter.

   There is an ON/OFF switch. Please make sure the transmitter is set to ON.

   Now that the transmitter is ON , you can pair the chair pad with the monitor.

5. Step 5 - Pair the Chair Pad with the Monitor

   
   

   Press the “PAIR” button until the status LED light turns a steady green. Make sure to complete the pairing before the light turns off! Press and release the center zone of the pad to complete the pairing. The Status LED won’t be steady anymore and the Sensor 1 red LED light will blink once to indicate it has been recorded. Your monitor can control up to 3 compatible devices. If you had a Lunderg Bed Alarm System or call button already paired it would then be added as Sensor 2 or Sensor 3.